Refer to the exhibit.
What type of cable is used for the ToR switch configuration shown for the S5248F-ON switches?
The “svc_rescue_state list” shows a node in service mode. How can the node be returned to normal mode?
What Dell PowerStore reference provides the user access to the entire set of product documentation, knowledge base articles, and product warranty and contracts?
Which Dell PowerStore network uses an appliance backplane?
Order the NDU operational steps.
Which formats are available to list alerts?
Refer to the exhibit.
A Storage Administrator noticed a drive LED blinking blue. What does this indicate?
What does the output of the PSTCLI command “nas_server show” display from a Dell PowerStore T?
Match the base enclosure SAS ports in column A to their corresponding expansion LCC ports in column B; when connecting a PowerStore base enclosure to a single expansion enclosure.
Through which network do external hosts connect to the cluster for data access?
A Storage Administrator notices a Major alert present in Dell PowerStore Manager relating to data protection. What action within the alert details slide-out panel is helpful in troubleshooting the data protection problem?
What is the result of setting a VLAN ID of 0 on a network when running ICW for Dell PowerStore?
Match the correct non-disruptive upgrade process step (answer column) with the correct sub-step (match column).
What describes Dell PowerStore X power down?
What describes the ICM and ICD networks?
A Storage Administrator ran a PSTCLI command on a Linux host. The error " -bash: pstcli: command not found" appears. How is the problem resolved?
During an emergency event an ESD-Kit is unavailable for FRU replacement. How can the work proceed?
When planning for a Dell PowerStore T implementation, how many IP addresses are required for the storage network?
Which reference source provides service information and FRU procedures for the Dell PowerStore?
Which experienced administrator role needs to address a warning about configuring VLTi?
During Dell PowerStore startup, both appliance nodes have rebooted in service mode. What must be done first to avoid management software conflicts?
In an unpopulated rack, at what U mark is the base enclosure racked?
What is the default log collection schedule?
A Storage Administrator is adding an appliance into an existing Dell PowerStore T cluster.
What is different about the management network configuration for the new appliance compared to configuring an initial appliance for the cluster?
Order the steps to prepare for an NDU process.
A Storage Administrator notices two fans in a Dell PowerStore are faulted. What describes the system behavior in this circumstance?
Which component can be replaced while the Dell PowerStore is up and running?
While on-site installing a Dell PowerStore system, the node A and В embedded module fault LEDs are alternating blue and amber (blue for 3 seconds). What does this indicate?
